admin管理员组文章数量:1577510
这是在近期网络技术培训中,熟悉了网络设备的配置,现将整理的常用配置命令及简要说明陈列于此。
路由器 路由器引导方式配置 Router(config)#boot system flash [IOS文件名] //从flash中引导 Router(config)#boot system fttp [tftp地址] [IOS文件名] //从TFTP中引导 Router(config)#boot syste rom //从rom中引导 说明:若有多条加载路径,启动时按顺序加载,若第一条加载失败则试图从随后路径中加载。 用户名与口令 router(config)#username tang password bang 本地登录认证 router(config)#line vty 0 4 router(config)# login //使用enable密码进行登录验证,也可以通过password语句设置密码。 router(config-line)#login local //使用已建立的用户名和密码进行验证 接口配置 router(config)#interface s0 router(config-if)#ip address 192.168.1.1 255.255.255.0 timeout时间设置 router(config)#line console 0 router(config-line)#exec-timeout [min] [sec] //无动作时超时 router(config-line)#session-timeout [min] //会话超时 router(config-line)#absolute-time //绝对超时 权限设置 router(config)#privilege exec level [0-15] [命令] //[命令]为当前权限下允许执行的命令,如:show run 静态路由 router(config)#ip route [目的
本文标签: 路由器
版权声明:本文标题:CISCO3640路由器配置参考 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://www.elefans.com/xitong/1727806354a1131049.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论