admin管理员组文章数量:1576808
1."WARNING:Route:455 - CLK Net:trn_clk_OBUF may have excessive skew&nBSP;
because 0 CLK pins and 1 NON_CLK pins failed to route using a CLK
template."
Solution
This message informs the user that some loads on the clock net are not
clock pins. Therefore, the clock template that is normally uSED to connect
clock pins will not be used to connect the loads. A different routing that
involves local routing will be used, potentially inducing some skew on the
clock net.
Opening your design in FPGA Editor will allow you to see what loads are
connected to the clock net, and the cause of the warnings.
The amount of skew on the net will be reported in the Place and Route
report.
If the loads on the net shown in FPGA Editor are in accord with your
design, the skew reported in the PAR report is not critical for the
design, and the timing constraint requirement on that net is met, then
this warning can be safely ignored.
实例原因:在代码中用到这样的语句时(aa’event and
aa=’1’),aa不是时钟信号,最多只是时钟信号产生的一类周期信号,aa被作为了另一个
进程或模块的类似周期信号的作用。(我是在行场信号发生器中 出现的这样的问题,用产
生的行同步信号(行同步信号是由全局时钟信号驱动产生的)再去驱动产生场同步信号,产
生的场同步信号相对与输入的全局时钟,有一定 的倾斜)
2. "WARNING:Xst:647 - Input is never used."
or
"WARNING:Xst:648 - Output is never used."
Solution
This particular port has been declared in your HDL description, but does
not drive or is not driven by any internal logic.
Unused input ports will remain in the design, but they will be completely
unconnected. If the port is not intended to be used, this message can be
safely ignored. To avoid this message, reMOVe any loadless or sourceless
elements from your HDL description.
Output ports will remain in the final netlist and will be driven by a
版权声明:本文标题:c语言中的error和warning,ISE中常见WARNING和ERROR及其解决方法 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://www.elefans.com/dongtai/1727797558a1130428.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论