juniper路由器配置1

路由器配置1"/>

juniper路由器配置1

1， 增加端口配置模板

（1）需要子接口的端口配置 set interfaces fe-2/0/1 vlan-tagging              ――――在配置接口启用封装VLAN set interfaces fe-2/0/1 unit 424 vlan-id 424       ―――――配置子接口，VLAN 424 set interfaces fe-2/0/1 unit 424 family inet address 192.168.254.146/30  ――配置子接口地址 （2）无需子接口配置 set interfaces fe-2/0/23 unit 0 family inet address 222.60.11.154/29   ――直接配置地址 （3）E1口配置 set interfaces e1-3/0/0 encapsulation ppp 封装链路类型，包含PPP,HDLC，根据实际情况配置 set interfaces e1-3/0/0 e1-options framing unframed 封装帧格式，参数包含unframed,g704, g704-no-crc4 set interfaces e1-3/0/0 unit 0 family inet address 192.168.1.126/30 配置地址 （4）CE1配置 set interfaces ce1-4/0/0 clocking external set interfaces ce1-4/0/0 e1-options framing g704-no-crc4 set interfaces ce1-4/0/0 partition 1 timeslots 1-31    ――――设置信道1及时隙1－31 set interfaces ce1-4/0/0 partition 1 interface-type ds  ――――子接口类型DS set interfaces ds-4/0/0:1 encapsulation ppp         ―――――配置子接口封装ppp set interfaces ds-4/0/0:1 unit 0 family inet filter input NYYH set interfaces ds-4/0/0:1 unit 0 family inet address 10.238.173.197/30  ――――配置地址 （5）策略配置 set firewall filter shigonganjuMAS term 1 from source-address 10.238.173.180/30 set firewall filter shigonganjuMAS term 1 then accept set firewall filter shigonganjuMAS term 2 from source-address 10.238.173.0/24 set firewall filter shigonganjuMAS term 2 from source-address 10.238.179.0/24 set firewall filter shigonganjuMAS term 2 then discard set firewall filter shigonganjuMAS term 3 then accept set interfaces fe-2/0/0 unit 44 family inet filter input jiaotongyinhangduanxin―――将策略应用至子接口。
  日常维护命令
1   查看序列号show chassis hardware
2   查看硬件show chassis hardware
3   查看软件版本show version
4   查看CPU  show chassis routing-engine
5   ping命令
ping 192.168.1.254 rapid    #快速ping地址  
6   查看设备告警信息 show chassis alarms 
7   查看详细的硬件温度及状态信息 show chassis environment 
8   收集CASE需要的信息request support information




本文转自小侠唐在飞 51CTO博客，原文链接：，如需转载请自行联系原作者